Method 1 : As Suro mentioned, this method involves specifying design parameters such as Steel and concrete strength (FYMAIN, FC), Clear cover for the bars, etc. After you get a successful analysis run, come back to the Modeling mode. Also, check the output file for warnings or errors, and if there are any, make the necessary changes to avoid those. After the analysis is completed, go to post-processing, view the displacements, member forces and plate stresses to ensure that they look reasonable. Again, any of the tutorials in the Getting Stared manual show you the procedure. The three tutorials in the Getting Started manual all illustrate the steps for doing these.Īfter you complete the model generation, run the analysis. Go on to assign properties to the members, thickness for the elements of the slab, supports for the structure, and loads. With this, the geometry of the model will be complete. If you plan to include beams and columns in the model, those should be defined using frame members (line entities). Tutorial 3 of the Getting Started manual shows four methods of which two involve mesh generation. There are various methods available for creating a plate mesh. The slab itself should be defined using a mesh of plate elements.

1) Generating the model consisting of the slab and other entities such as beams and columns.Ģ) Analyzing the model to obtain the displacements at the nodes, forces and moments in beams and columns, and stresses in the plate elements used to model the slab.ģ) Designing the slab to obtain the reinforcing details

Staad pro rc designer tutorial